Mini-Mill X2 Clone (CX605) Digital Readout (DRO) Mounting Video

coflynn

Registered
Registered
Joined
Aug 31, 2013
Messages
4
Hi All,

I recently did a simple mounting of some digital readouts on my Busy Bee CX605 mini-mill. I'm not doing super-accurate work with it (a lot of enclosure building) so made some pretty simple brackets. Anyway I made it in video form as it was easier than taking a ton of photos, so if it's helpful to anyone else:

[video=youtube;gUAQUITKijY]http://www.youtube.com/watch?v=gUAQUITKijY&hd=1[/video]

There's a few other videos on my mill in that playlist but the DRO mounting is probably most interesting. These are the 90 degree adapters I used for routing the scale cables: http://www.ebay.com/itm/Mini-USB-Ma...er-/161065366370?ssPageName=ADME:L:OC:US:3160

Regards,

-Colin
 
Back
Top