- Joined
- Jan 7, 2015
- Messages
- 2
Hi All,
I have a Microlux 7x14" spindle head that I recently installed taper bearings on and wanted to know if anyone on this forum has done the same. After reassembly I noticed the Optical Interrupter was not tight between the spacers. Maybe .20 - .03" axial slop. Would anyone know if this is normal? FYI - I'm pretty sure that the races for both new bearings are fully seated or should I check again?
Thanks!
M.
I have a Microlux 7x14" spindle head that I recently installed taper bearings on and wanted to know if anyone on this forum has done the same. After reassembly I noticed the Optical Interrupter was not tight between the spacers. Maybe .20 - .03" axial slop. Would anyone know if this is normal? FYI - I'm pretty sure that the races for both new bearings are fully seated or should I check again?
Thanks!
M.