1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. PLEASE: Read the FORUM RULES BEFORE registering!

    Dismiss Notice

Mills: RF31 or Enco 105

Discussion in 'ASIAN LATHES & MILLS' started by rock_breaker, Mar 15, 2017.

  1. rock_breaker

    rock_breaker United States H-M Supporter - Premium Content H-M Supporter-Premium

    Likes Received:
    105
    Trophy Points:
    43
    Location:
    17954 CR 15
    City:
    Yellow Jacket
    State:
    Colorado

    -Return to Top-

    I have in storage an RF 31 that is newer than My Enco 105 mill/drill. The RF 31 was dismanteled when put into storage. It was functional when I bought it at auction but I haven't ran it. My question is even though these machines are almost identical does one have an advantage over the other? The Enco is in the shop and used when needed. I put a digital scale on the "Y" axis but this could be put on the RF 31 with a new bracket. Again the question is: Does the RF31 have advantages that warrant approximately 1 week labor to make the change?
    Have a good day
    Ray
     

Share This Page