- Joined
- Nov 23, 2020
- Messages
- 791
Hi all. Been working on this project slowly. This is from plans purchased by Phil Vandelay, and I decided to keep the metric dimensions. Material sourcing is going slowly. I bought 1 x 5/8” think plate as a drop from my local MSM, and have been searching my scrap piles for raw materials as well. Here is where I am so far.
I’m not going to bore the motor ring till I decide on what I’m going to use. I think the toughest part to source $ wiseis a 16” 40x40mm square bar, and a 8” Aluminum round bar slug 4” thick for the drive wheel. Anyone have any materials for sale/trade?
I’m not going to bore the motor ring till I decide on what I’m going to use. I think the toughest part to source $ wiseis a 16” 40x40mm square bar, and a 8” Aluminum round bar slug 4” thick for the drive wheel. Anyone have any materials for sale/trade?