Looking for dimensions of the clutch kick-out block for a 5914

As I tell the Atlas people, if someone needs a part and if it isn't fairly readily available on the used market (eBay, etc.), the steps are:

1. Look up the Clausing part number in a parts manual. There are a few of them in the Clausing section of our Downloads. So Step 0 might be:

0. Find a parts manual.

2. Call Clausing @ 800-323-0972, ask for old Clausing parts, and then ask whether or not they have any of the parts. If they do, either buy it or don't, but don't waste time asking for the drawing. If they don't, ask them to email you a PDF (or TIF if you can handle it) of the drawing or drawings. When you get it or them, upload to the Clausing Drawings folder in the Clausing section of our Downloads.

3. Make the part(s).
 
This was an old thread resurected.

First rule of hobby machining: Never buy what you can make unless the finished item is cheaper than you can buy the material to make it for.
 
That is generally true, at least if you are capable of making it close enough to the original to work. However, Rule 1A is that if you only have time enough to make either the item you need or the second item that you need the first one in order to make, you should buy the first one and make the second one.
 
Back
Top