- Joined
- Jun 8, 2016
- Messages
- 603
I have made the decision to power some equipment with a RPC. I will use a 5hp RPC. I am buying a panel and adding an idler motor to it. To that end, does it matter which 5hp 3ph motor I use? I have found one semi-local that I can pick up without shipping for $100 bucks. It is a Dayton 200/230/460 at 1750 rpm. It was taken off of an air compressor so the gentleman could re-motor it to single phase. Tag says it is continuous duty.
As I understand it, any 5hp 3ph will work, and I think they all work the same. I just wanted to make sure.
Thanks in advance.
As I understand it, any 5hp 3ph will work, and I think they all work the same. I just wanted to make sure.
Thanks in advance.