Might I ask why do you think you need one. Your dials should be accurate enough . At least with in one are two turns . You measure the part with a micrometer and take a cut .Then you measure again and take another . Lets say I am turning a piece fro 1 inch stock to 1/2 inch . I just scratch the part with the tool set dial to 0 take what ever ,say .100 in feed engage feed take cut I know I should have about .400 more to take off. take 2 more cuts of .100 each . Now measure if the world was perfect I would be at .700 but it is not I read .675 with mike take a .075 deep cut . Measure it reads .599 all is good Toke .050 measure. now I need.049 more Take .025 measure mike reads.524 take .022 measure part comes out .001 over size .Pick up file give it a few wacks part on size. Now a indicator are a travel dial for the carriage I can understand.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.