gem fixed position model 333

[oughtsix]

Inherited this thing, I can see it is an indicator, but since I am still a "budding" machinist, so I don't know how to use it. Or if I need it all. Any one know where I can get instructions or what specifically it is used for.

Thanks,

-06

 

[drs23]

Standing by for someone with more knowledge than me. I wanna know too!

 

[ScrapMetal]

It appears that it will work like any other standard DTI if you can find a replaceable tip for it. I found one on the 'bay where you can see how the tip is set up - http://www.ebay.ca/itm/GEM-MOD-333-...rg=20140620075055&rk=1&rkt=10&sd=331235873388

Hope that helps,

-Ron

 

[oughtsix]

Thanks ScrapMetal, I didn't realize it was missing the tip. I could have figured it out if it had been complete. I was trying to figure out how you would place the black blade part on or in your work. Good to know I'm not a complete idiot..... I WAS missing parts !!

-06