-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
Gear covers
- Thread starter macher
- Start date
No, when I purchased the lathe only the two partial covers were with it.
- Joined
- Dec 25, 2011
- Messages
- 10,507
OK. Then I understand how your wife must have gotten her chuckle. 
) If you decide to try to find a full cover, look for one for 101.07403. Same cover but much more likely to be listed that way.
Robert D.
) If you decide to try to find a full cover, look for one for 101.07403. Same cover but much more likely to be listed that way.Robert D.
OK. Then I understand how your wife must have gotten her chuckle.
Robert D.
I went through the belt train and tightened all the nuts. When I put the gear covers back on I noticed the hole for the number 10 screw in the rear of the cover was oversized. I held the right side cover as far to the right as possible when I tightened it. The left side cover also had an oversize hole and I held the cover to the left. When I flipped the switch and the lathe started there was no noise.
Dave.