i made this about a month ago and kind of forgot about it , but heres my take on a spider nut for my g0602 .
i am pretty sure i could have made it fit behind the door almost completely , but i have plans on doing away with the three sheave pulley once i do a three phase motor and vfd conversion and didnt want to take a chance on it being to short .
so it sticks out a bit for now . i do need to take a file and clean up the hole in the door a bit .
i used a whizzy wheel and a file for the spanner slots , and the holes for the set screws are tapped 1/4-28 , once i get back on my feet i am going to make some brass tipped set screws
i am pretty sure i could have made it fit behind the door almost completely , but i have plans on doing away with the three sheave pulley once i do a three phase motor and vfd conversion and didnt want to take a chance on it being to short .
so it sticks out a bit for now . i do need to take a file and clean up the hole in the door a bit .
i used a whizzy wheel and a file for the spanner slots , and the holes for the set screws are tapped 1/4-28 , once i get back on my feet i am going to make some brass tipped set screws