Follower rest for trade.

Jim F

Jim F

Registered
Registered
Joined
Sep 24, 2020
Messages
1,907
Bought this thinking it fit a SB9, as all the other stuff pictured.
It is for an 11" lathe of some sort, best I can tell.
Center is 1" above center on my SB9, it matches the bolt pattern on mine, but hits the flat way before the front hole lines up.
Will trade for stuff I can use on my small under-powered machines.
Can send pics.
only marks are dot 11 dot.
 
Jim F said:
Bought this thinking it fit a SB9, as all the other stuff pictured.
It is for an 11" lathe of some sort, best I can tell.
Center is 1" above center on my SB9, it matches the bolt pattern on mine, but hits the flat way before the front hole lines up.
Will trade for stuff I can use on my small under-powered machines.
Can send pics.
only marks are dot 11 dot.
Click to expand...
I'd like to see pics, probably others would too.

I'm looking for a follow for my 10" Taiwanese (Enco). I know the bolts holes won't line up unless by extreme good luck, but maybe the follow and/or the carriage on the lathe can be modified to fit. I'd take a chance on something iffy if the price was reasonable enough. I know you said Trade but I don't have much trading stock, I might have to send cash.

Mark B in Seattle
 
bulgie said:
I'd like to see pics, probably others would too.

I'm looking for a follow for my 10" Taiwanese (Enco). I know the bolts holes won't line up unless by extreme good luck, but maybe the follow and/or the carriage on the lathe can be modified to fit. I'd take a chance on something iffy if the price was reasonable enough. I know you said Trade but I don't have much trading stock, I might have to send cash.

Mark B in Seattle
Click to expand...
I will post pics tomorrow.
 
Pics showing a 5/16 rod in my 3 jaw.
front bolt not shown, due to rest hitting the flat way, bolt won't start.
 

Attachments

  • IMG_20220412_152419184.jpg
    IMG_20220412_152419184.jpg
    69.2 KB · Views: 23
  • IMG_20220412_152428372.jpg
    IMG_20220412_152428372.jpg
    67.1 KB · Views: 23
  • IMG_20220412_152523152_HDR.jpg
    IMG_20220412_152523152_HDR.jpg
    139.7 KB · Views: 18
  • IMG_20220412_152556178_HDR.jpg
    IMG_20220412_152556178_HDR.jpg
    110.3 KB · Views: 20
  • IMG_20220412_152441433.jpg
    IMG_20220412_152441433.jpg
    65.1 KB · Views: 24
Jim F said:
Pics showing a 5/16 rod in my 3 jaw.
front bolt not shown, due to rest hitting the flat way, bolt won't start.
Click to expand...
Jim, thanks for the pics. Not compatible with my lathe, too bad. Good luck finding it a new home.

-Mark
 
Update, this fits an 11' lathe.
Will not fit a SB10L.
 
You must log in or register to reply here.
Back
Top