- Joined
- Mar 11, 2012
- Messages
- 124
Hey guys,
I have a question about my excello mill. I just picked it up and got everything wired up. I ran it for a while the other night and when I came back in the shop the next day I noticed a puddle of oil on the table. There was oil on the head of the mill just above where spindle is and the cap screws are located. It wasn't a ton of oil but it wasn't a little either. If this turns out to be a problem I need to address how hard is it to get apart and are there any good references out there that I can look at.
Pas a side note I just ordered a crap load of stuff for it. Hopefully it gets here this week.
Joe
I have a question about my excello mill. I just picked it up and got everything wired up. I ran it for a while the other night and when I came back in the shop the next day I noticed a puddle of oil on the table. There was oil on the head of the mill just above where spindle is and the cap screws are located. It wasn't a ton of oil but it wasn't a little either. If this turns out to be a problem I need to address how hard is it to get apart and are there any good references out there that I can look at.
Pas a side note I just ordered a crap load of stuff for it. Hopefully it gets here this week.
Joe
