Drum switch to Motor with board If I eliminate the board?

I'm trying to identify the windings but I only see 5 "winding wires" coming out of the motor:
red
yellow
brown
black
darkish blue
should be 6.
there must be a splice, let me look at the 220 volt hookup for a bit..
 
Is there a grey wire on your drawing? What is that one connected to the black that goes to L1?
MS
ps yes your drawing looks workable if you can account for all 6 winding wires
 
I'm trying to identify the windings but I only see 5 "winding wires" coming out of the motor:
red
yellow
brown
black
darkish blue
should be 6.
there must be a splice, let me look at the 220 volt hookup for a bit..

I have
Blue
Yellow
Brwn
Red
Green
Black
Here's a better image, I think this is what you were saying
20170331_133117.jpg
 
Does that blue cap wire go straight out to the board or does it take a detour into the windings first. I'm having trouble visualising which two wires are the start winding
Mark
 
Yellow is one end of the start winding, then which is the other end?
M
 
Yellow is one end of the start winding, then which is the other end?
M

I thought the blue was the switch to the start winding. And green was the other end of it.
And then yellow would be the run?

wouldn't the capacitor and centrifigul switch attach to the start winding?
 
I was trying to correlate this Baldor diagram to your motor, the colors are different of course but I can't account for the 6 winding ends.
Baldor L1319M Diagram.jpg
 
I thought the green one goes from the terminal board to the cap..? No? Something I'm missing here
M
if yellow and green are the start winding your drawing may not work
 
Last edited:
Back
Top