- Joined
- Sep 22, 2019
- Messages
- 942
Well, I got 'em all cut and drilled.
No to figure how to face off the end of several that are not square and a bit too long.
Would like to get them all with in about .005 or so. Not a critical thing though, just would like to do it is all.
Debating whether to stand them on end in the vise to end mill or lay them down and side mill the end.
What say you folks?? I'm sure one way would be better than the other, just don't know which!
No to figure how to face off the end of several that are not square and a bit too long.
Would like to get them all with in about .005 or so. Not a critical thing though, just would like to do it is all.
Debating whether to stand them on end in the vise to end mill or lay them down and side mill the end.
What say you folks?? I'm sure one way would be better than the other, just don't know which!
