Drawbar For Enco 9x42

Slayer_MN1

Registered
Registered
Joined
Jan 27, 2014
Messages
24
Hey all, I recently acquired this 9x42 Enco and am in need of a drawbar, can you tell me what length I need to order?

E0082F9B-E0FC-4AEF-858C-2614D214FDB1_zpsewmfgfca.png

Thanks

Steve
 
You could measure the tube depth of the spindle , I'd hold a collet in and measure from the top down then I'd add an inch , not real hard to figure out . I'll bet it's around 20" or so 21" sounds right but ck it.
 
Call Dorian up and tell em you have a step pulley Enco head and want a draw bar. They make the best and supply darn near every retailer that sells USA made drawbars.

michael
 
A coupling nut welded to all thread, trim to length. Simple and cheap.
John.
 
Back
Top