Copycat Mill Build.

oh good your back on track
I'm not getting email notices?
steve
 
the website is giving me fits
i double posted because the first one didnt show right up
steve
 
steve

a lot of my email from the forum are going to my bulk mail

lanham​
 
if you have questions send them to my email jumpscam@yahoo.com i'll see it sooner there
yahoo is giving me trouble ever since they updated also but i check my email often
steve
 
Have not been working on the mill cause I have been moving. Transportation office told me months ago that since this is my terminal assignment they would move me without my retirement orders. I bought a house and gave my notice to post housing that I would be moving within a month, then went to transportation to schedule my move. Sorry sarg, no retirement orders no free move. :angry:

I decide to look for the positive, I got a van and a ford ranger and its only 85 miles, ill make it an adventure and have fun, I've got a month right?

what could go wrong?:whiteflag:

image.jpg image.jpg image.jpg
 
check you motor tuning screen
I think they are trying to move too fast
and what do you have the switches set to on the drivers?
I think you have the same motor and drivers as me
Steve
 
Steve,

All my parts are the same as yours. I'm doing some rewiring now that will hopefully fix it.

I lost the nut that goes to the z axis, I think it is a m16x1, do you know where I can find one, been looking all over and can't find one

Lanham
 
the only one i could find on ebay is not cheap item Number
380883988225 but there is no locking set screw
try contacting the company you got the screws from?
Steve
 
Back
Top