My Grizzly G4003G lathe takes "250 series" tool holders,or so I thought. All my tool holder say "250" on them.
I recently acquired a used Phase II tool holder that plainly says "250" on it as well, but is an entirely different size. Doesn't even come close to fitting my tool post.
I've been assuming that the "250" was how to identify the size.
See below. Is the Phase II mis-marked or something?
I recently acquired a used Phase II tool holder that plainly says "250" on it as well, but is an entirely different size. Doesn't even come close to fitting my tool post.
I've been assuming that the "250" was how to identify the size.
See below. Is the Phase II mis-marked or something?
Last edited: