- Joined
- Nov 22, 2010
- Messages
- 371
I need to have a way to hold things in the spindle like cutter or drills, etc.
i see r8 ' Holders' and i see collets that must have to go into a special holder
i must admit i'm confused ( not unusual) My old mill 25 years ago ( Like a Rong fu as I recall) took a collet and was drawn into the spindle with a Bar threaded to the collett from up near the drive belts.
How will the SX3 seig handle this department ????
Thanks and i'm sorry for asking such a basic question
joe
i see r8 ' Holders' and i see collets that must have to go into a special holder
i must admit i'm confused ( not unusual) My old mill 25 years ago ( Like a Rong fu as I recall) took a collet and was drawn into the spindle with a Bar threaded to the collett from up near the drive belts.
How will the SX3 seig handle this department ????
Thanks and i'm sorry for asking such a basic question
joe