- Joined
- Dec 13, 2015
- Messages
- 17
I just purchased a Jet 1340 and to make room for it my Colchester Student lathe has to go. Frankly, this lathe needs some work. Biggest issue is the ways. Comes with three chucks, faceplate, bridge, and factory tool holders. The lathe is under power in my shop just outside Jonesboro, Arkansas.
If I can not find a buyer I will part it out. If you need a Colchester Student part(s) send me a PM so I can put you on the list.
Mods. If this thread is not appropriate in this forum would you please tell me where to put it (be nice) and I will comply.
Thanks,
BIB OVERALLS
If I can not find a buyer I will part it out. If you need a Colchester Student part(s) send me a PM so I can put you on the list.
Mods. If this thread is not appropriate in this forum would you please tell me where to put it (be nice) and I will comply.
Thanks,
BIB OVERALLS