[Documentation] Cincinnati Traytop Hydra-shift Restoration

Did you see the photo of my disassembled taper attachment earlier in this thread?
 
Yes, I was just hoping to see some photos of the components fully assembled. I think I know the pieces I am missing, a visual would help. Thanks for replying. I will drop a photo of my assembly tomorrow, so you can see where my needs are.
 
I have circles around where I think I am missing parts. The first picture you posted shows the saddle piece that I am missing. Pretty sure I can make that. Not sure what is missing on my first picture. Any insight you can provide on operation would help too. Do I need to disengage the feed to allow the taper to work? Thanks for updating this old thread!!
Taper #1.jpg

Taper #2.jpg
 
Back
Top