Camel Back Casting Setup For Dovetail Machining

[chevydyl]

Sorry I don't mean to be a troll but I find it kind of irritating when a guy asks one question and then someone asks me a bunch of questions and gives advice on how to do something I didn't ask about. Ie, I knw how to run this face mill over a part, but how the heck would you hold this oddly shaped item.... it's happened to me so many times and I know sbx was thinking it lol

I know from experience that holding the camelback can be a challenge, a vice won't do

 

[sbx]

The tilt table definitely looks like a good set up. I don't have one, and hesitated in getting one due to limited z height in my mill. If the v blocks don't work, that will be my next purchase.