- Joined
- Jun 15, 2015
- Messages
- 35
Here's mine going up right after it was delivered. It has since been moved to another bench, but it was rigged the same way then. Luckily, I did quite a bit of rigging in my job over the years. This was a piece of cake as they say. Those shop cranes are a wonderful thing to have around. They don't move too well laterally, so I lower the load until it's just about the legs before moving a load. If I can I'll put the load right on the legs. With this lathe, it wasn't possible without using lumber.
If you're not careful, though, rigging can hurt you and wreck equipment.
If you're not careful, though, rigging can hurt you and wreck equipment.