• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.
  • PLEASE: Read the FORUM RULES BEFORE registering!

asian lathe carrige feed rates

ultralight

Swarf
Registered Member
Joined
Dec 24, 2014
Messages
3
Likes
0
#1
I have a 7x12 mini lathe. As far as I have been able to find out the standard fee rate of the carriage is 256 threads per inch. I am doing some upgrades to the lathe. I changed the drive pulley from the stock 1.89 to 1 to a 3 to 1 setup with and an xl belt. I think ,but am not sure, that the new rate will increase to about 417 tpi. Can anyone conferm my figures or give me their own conclusions. Thanks Dave
 

owl

Active Member
Active Member
Joined
Mar 15, 2012
Messages
65
Likes
47
#2
The feed is geared to the headstock, not the motor, so your drive doesn't affect the feed.
 
Container Above bottom breadcrumb