- Joined
- Jun 23, 2019
- Messages
- 87
Has anyone successful used a 3d probe mounted horizontal to set tool length?
Ok, poorly formatted question. I'm thinking TTS and Master tool to compare others against. If I have a 3d probe why should I pay another $100-$800+ for a tool offset measurements device? Put in the master, zero everything, insert next tool and populate tool table. Where is my thinking going off the rails. Has anyone tried it? Huh? Sorry, wasn't mocking.Huh?
Ok, no one had tried it. ThanksHas anyone successful used a 3d probe mounted horizontal to set tool length?