- Joined
- Nov 1, 2022
- Messages
- 140
I've been getting good results with PLA, so decided to try Sunlu ABS. First test is basically a coin sized part. It seemed to be going well, altho watching it ti seemed like the material was balling up some. Then the part lost adhesion to the bed during the last few layers.
I don't have an enclosure for the printer, the room is in the mid-60's F but not drafty.
Plate temp: 95C
Nozzle: 240C
Suggestions for tweaks?
I don't have an enclosure for the printer, the room is in the mid-60's F but not drafty.
Plate temp: 95C
Nozzle: 240C
Suggestions for tweaks?