suburban

I have a Suburban Fly cutter and their 5" bar . I started getting familiar with it by facing off all my aluminum chill blocks. Roughly 4"x5" one inch thick 6061 blocks . The fly cutter works great but I have to run it in low range in my mill, which is 370 RPM and slow table feed . I can run it...

A short vid , fly cutting jaws of an old vise I found at the scrap yard . The aluminum jaws were kind of chewed up and a few places where cutters cut into the jaws. Welded those over then milled and fly cut them. No clue what make or model this vise is...was on an old Supermill at the junk yard...

Saw this vise on an old Supermill at the scrapyard I frequent. It was outside, covered in gunk and chips but the handle still turned so I grabbed it for scrap price. Took about an hour to scrape all the encrusted chips and gunk out of it, then about an hour or so with wire brushes and wheels...