igaging

Does anyone know of a supplier of JUST the magnetic scale portion. I have a 6” scale and read head that I don’t have a use for, and would like to get 24” of the magnetic scale material to use with the read head I already have. Not worth the trouble? Not fiscally sound? Penny wise and pound...

i Purchased a 3 axis IGaging EZ-View DRO kit, it had a 24", 12" and 6" scales in the kit. for my mill , it was going to be challenging to install the Y & Z axes without modifications the X was relatively straightforward, but i decided to put it on the rear of the table- a little complication. it...

I Gaging DRO Installation i got the i gaging dro's for my Shenwai SW900B lathe. a close up of the scale installation, below i got the 6" cross slide (Y axis) installed and the display positioned on my vfd enclosure. to install, lay out where the scale and dro slider will fit and be...

Good day, By popular demand, I finally added support for iGaging Absolute scales to the TouchDRO (using MSP430 "Universal" controller firmware). The firmware is still in "BETA" version and can be downloaded from my blog's "Downloads" section (http://www.yuriystoys.com/p/downloads.html). In...

I have a Igaging speedmic and a origin caliper. I'm trying to read the data off the SPC jack, but Igaging won't confirm the data output. They claimed it was the same as mitutoyo (52 bit), but it's not. Anyone familiar with the output specifications? I built an arduino / mitutoyo interface a few...