Hit the Jackpot !!!

barnett

barnett

H-M Supporter - Gold Member
H-M Supporter Gold Member
Joined
Mar 14, 2014
Messages
175
I went to an auction Friday and hit the jackpot, a mill and a lot of tooling for it. Here goes... dividing head w/ plates and tailstock...woodrift cutters, 6" palmgren swivel vise... 3" boring head...mill clamp set....rotary cross slide table...4 large parallels...tap wrench...small angle plate...coaxial indicator...mill cutters and slitting saws... collet rack and collets and also came with a phase converter. all for 1 money !!!
.mill.JPGmill2.JPGtool.JPGtool2.JPGIMG_0043.JPGtool4.JPG

tool3.JPG

tool5.JPG
 
Nice haul.
 
Very nice! You were the right guy in the right place at the right time!
 
Wow! One stop milling setup.
Congratulations!

-brino
 
Yes, the motor was taken off so they could get it out of the basement/garage it was in. It was a shame I didn't need another lathe, they sold a 9" southbend and a 14" grizzly for less than $600 each with both chucks and the SB had a taper attach and QC gearbox.
I'll be selling my other mill, its a U.S. Machine tool horizontal with a vertical head too. I gotta make some room.
 
You must log in or register to reply here.
Back
Top