- Joined
- Jun 12, 2016
- Messages
- 14
Hey everyone I'm trying to wire my enco 110-2075 to a drum switch. Basically just pulled the power supply and the motor wires off the control board and wired them directly to the drum switch. The motor and capacitor get real hot and hardly turn but I am getting forward and reverse. Also the diagram on the motor casing shows 6 wires but there are only 4 leads that come out the casing. Any ideas? The motor was running fine before I did all of this but the spindle switch was bad and would only go in one direction.
Sent from my SAMSUNG-SM-N910A using Tapatalk
Sent from my SAMSUNG-SM-N910A using Tapatalk