- Joined
- Nov 29, 2015
- Messages
- 439
If you are changing the resistors that I’m thinking about? Then they went bad/smoked because your forward-reverse switches are bad. You will need two new micro switches. Don’t bother trying to clean them, BER, just buy new ones. And the trimers on the board only get turned when you tune the board to the motor, after that, they are torque sealed. And it really doesn’t mean that much in your end result of the whole shebang working. If you think that was the problem with the feed not working, it was not. And I’m not saying it wasn’t a problem, just not the one that killed your Power Feed.
Two new switches ordered. If I'm lucky I'll get to do some testing this week once parts get in.
There were 4 resistors that were waaay out of tolerance. The bad ones were rated at 18k, 27k, 300k and 2.7 million.
I hope you guys are going to help me rebuild the top end. It's quite noisy.