The plate made it! The last couple of inches I had to remove the bike hanger and pulley. Then push it the rest of the way. Which was easy.
The plate made it to it's new home!
Now to remove the rails just lift the plate via the 3 mounting points until you can see light between the rails and the plate.
At this point the plate is still sitting on the slide rails.
The plate made it! The last couple of inches I had to remove the bike hanger and pulley. Then push it the rest of the way. Which was easy.
The particular setup was 1 to 1 on leverage so It didn't work just pulling on the rope.
The plate didn't slide easy...so I thought I'd attach a pulley to the bench. I used a single pulley and a bike hanger. Screw in type.
Starting to slide it down the rail was the hardest part. As the plate went from flat to sloped. A little more lifting than I wanted.
expressline99

The plate made it! The last couple of inches I had to remove the bike hanger and pulley. Then push it the rest of the way. Which was easy.

Media information

Album
Moving the surface plate from the van to the stand
Added by
expressline99
Date added
View count
750
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/67 second(s)
ISO
200
Flash
On, fired
Filename
DSCN5945.JPG
File size
2.1 MB
Date taken
Sat, 15 July 2017 3:37 PM
Dimensions
3648px x 2736px

Share this media

Back
Top