There are mounting pads on the bottom of the plate. These had to fit between the rails. I had to keep adjusting as I slid it.
The plate didn't slide easy...so I thought I'd attach a pulley to the bench. I used a single pulley and a bike hanger. Screw in type.
Starting to slide it down the rail was the hardest part. As the plate went from flat to sloped. A little more lifting than I wanted.
A close up of the factory installed mount pads. Had to make sure these didn't get pryed off while sliding it down the rail.
There are mounting pads on the bottom of the plate. These had to fit between the rails. I had to keep adjusting as I slid it.
Another view of the rails on the stand. The mounting screws are turned down below the level of the sideways 2x4s
A view of how the rail looked attached to the ledge on the pallet.
I placed a single support under the center. I made sure that the 2x4s were directly supporting the load.
expressline99

There are mounting pads on the bottom of the plate. These had to fit between the rails. I had to keep adjusting as I slid it.

Media information

Album
Moving the surface plate from the van to the stand
Added by
expressline99
Date added
View count
784
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/30 second(s)
ISO
170
Flash
On, fired
Filename
DSCN5940.JPG
File size
2.2 MB
Date taken
Sat, 15 July 2017 3:18 PM
Dimensions
3648px x 2736px

Share this media

Back
Top