I added a ledge for the rails to sit on directly to the shipping pallet the surface plate was on.
I placed a single support under the center. I made sure that the 2x4s were directly supporting the load.
I made sure the rails were as wide as the stand. Which I made an inch wider than the plate for room to move. So it needed a couple of 25" spacers.
There was a slight slope from the truck to the stand. Roughly 6" of drop. These are the rails I attached to the ledge I put on the stand.
I added a ledge for the rails to sit on directly to the shipping pallet the surface plate was on.
This is where I got the idea of where I could put rails to slide it on. So it needed a cleat. See next pictures
Just another angle of the garage from where I was moving the plate...
I had the plate on it's shipping pallet... plus One more pallet that I had in the warehouse.
expressline99

I added a ledge for the rails to sit on directly to the shipping pallet the surface plate was on.

Media information

Album
Moving the surface plate from the van to the stand
Added by
expressline99
Date added
View count
866
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/131 second(s)
ISO
64
Flash
On, fired
Filename
DSCN5934.JPG
File size
2.2 MB
Date taken
Sat, 15 July 2017 2:23 PM
Dimensions
3648px x 2736px

Share this media

Back
Top