This is where I got the idea of where I could put rails to slide it on. So it needed a cleat. See next pictures
I made sure the rails were as wide as the stand. Which I made an inch wider than the plate for room to move. So it needed a couple of 25" spacers.
There was a slight slope from the truck to the stand. Roughly 6" of drop. These are the rails I attached to the ledge I put on the stand.
I added a ledge for the rails to sit on directly to the shipping pallet the surface plate was on.
This is where I got the idea of where I could put rails to slide it on. So it needed a cleat. See next pictures
Just another angle of the garage from where I was moving the plate...
I had the plate on it's shipping pallet... plus One more pallet that I had in the warehouse.
What I had to do.
expressline99

This is where I got the idea of where I could put rails to slide it on. So it needed a cleat. See next pictures

Media information

Album
Moving the surface plate from the van to the stand
Added by
expressline99
Date added
View count
730
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/62 second(s)
ISO
67
Flash
On, fired
Filename
DSCN5933.JPG
File size
2.3 MB
Date taken
Sat, 15 July 2017 2:17 PM
Dimensions
3648px x 2736px

Share this media

Back
Top